Nortel Media Gateway 3200 User Manual page 130

•
acBoardConfigurationError - Sent when a board's settings are illegal - the trap
contains a message stating/detailing/explaining the illegality of the setting.
•
acBoardTemperatureAlarm - Sent when a board exceeds its temperature limits.
•
acBoardEvResettingBoard - Sent after a board is reset.
•
acBoardEvBoardstarted - Sent after a board is successfully restored and
initialized following reset.
•
acFeatureKeyError - Development pending. Intended to relay Feature Key
errors etc. (To be supported in the next applicable release)
•
acgwAdminStateChange - Sent when Graceful Shutdown commences and
ends. (Currently supported in H.248 only)
•
acBoardEthernetLinkAlarm - Ethernet Link or links are down.
•
acActiveAlarmTableOverflow - An active alarm could not be placed in the
active alarm table because the table is full.
•
acAudioProvisioningAlarm - Raised if the MG 3200 is unable to provision its
audio.
•
acOperationalStateChange - Raised if the operational state of the node goes to
disabled. Cleared when the operational state of the node goes to enabled.
•
acKeepAlive – part of the NAT traversal mechanism. If the STUN application in
the MG 3200 detects a NAT then this trap is sent out on a regular time laps - 9/10
of the acSysSTUNBindingLifeTime object. The AdditionalInfo1 varbind has the
MAC address of the MG 3200.
•
acNATTraversalAlarm - When the NAT is placed in front a MG 3200, it is
identified as a symmetric NAT - this alarm is raised. It is cleared when a non-
symmetric NAT or no NAT replace the symmetric one.
•
acEnhancedBITStatus - This trap is used to for the status of the BIT (Built In
Test). The information in the trap contains board hardware elements being tested
and their status. The information is presented in the additional info fields.
•
acPerformanceMonitoringThresholdCrossing - This log trap is sent out for
every time the threshold of a Performance Monitored object is crossed. The
severity field is 'indeterminate' when the crossing is above the threshold and
'cleared' when it goes back under the threshold. The 'source' varbind in the trap
indicates the object for which the threshold is being crossed.
•
acSS7LinkStateChangeAlarm - This alarm is raised if the operational state of
the SS7 link becomes BUSY. The alarm is cleared when the operational state of
the link becomes -SERVICE or OFFLINE.
•
acSS7LinkInhibitStateChangeAlarm - This alarm is raised if the SS7 link
becomes inhibited (local or remote). The alarm is cleared when the link becomes
uninhibited - local AND remote. Note that this alarm is raised for any change in
the remote or local inhibition status.
•
acSS7LinkBlockStateChangeAlarm - This alarm is raised if the SS7 link
becomes blocked (local or remote). The alarm is cleared when the link becomes
unblocked - local AND remote. Note that this alarm is raised for any change in the
remote or local blocking status.
•
acSS7LinkCongestionStateChangeAlarm - This alarm is raised if the SS7 link
becomes congested (local or remote). The alarm is cleared when the link
becomes uncongested - local AND remote. Note that this alarm is raised for any
change in the remote or local congestion status.
User's Manual 130
MG 3200
Document # LTRT-72704