Nortel Media Gateway 3200 User Manual page 259

H.248 User's Manual
ini File Field Name
EnableSilenceCompression
EnableStandardSIDPayloadTyp
e
EnableSTUModemDetection
EnableTrunkTestingTones
EVRCRate
FaxBypassPayloadType
FaxModemBypasDJBufMinDela
y
FaxModemBypassBasicRTPPa
Version SN09
Table 12-4: Media Processing Parameters
Description
Enables or disables Silence
Suppression Mode.
0 = Disable =
SILENCE_COMPRESION_DISABLE
1 = Enable =
SILENCE_COMPRESION_ENABLE
2 = Enable without adaptation =
SILENCE_COMPRESION_ENABLE
_NOISE_ADAPTATION_DISABLE
When set to 1 (Enable), SID packets
are sent with the RTP SID type (RFC
3389).
0 = Disable; 1 = Enable
Enables or disables detection of two
tones required for an STU modem.
0 = Disable; 1 = Enable
Enables or disables trunk testing
tones.
0 = Disables trunk testing tones
1 = Enables trunk testing tones
This parameter is used to configure
the EVRC coder bit rate.
0 = Variable Rate
1 = 1 kbps
2 = 4 kbps
3 = 8 kbps
Modifies the Fax Bypass Mode RTP
packet's payload type.
If congestion (if the selected payload
type is already used for other
coders/modes), then a
TP_SETUP_PARAMETER_INVALID
_ERROR is issued and the payload
type is set to the default value (102).
It is the user's responsibility to avoid
congestion with other payload types.
Determines the Jitter Buffer constant
delay (in milliseconds) during a Fax &
Modem Bypass session. (The
minimum Jitter Buffer Size).
Sets the basic Fax / Modem Bypass
259
12. Appendix - Individual ini File Parameters
Host/Manual
Default Value
102
Valid
Range
0 0 to 2
0 0 or 1
0 0 or 1
0 0 or 1
0 0 to 3
0 to 127
40 0 to 150
0 0 to 3
October 2006