Nortel Media Gateway 3200 User Manual page 253

H.248 User's Manual
ini File Field Name
TDMBusmasterSlaveSelection
TDMBusNetrefOUTPUTMODE
TDMBusNetrefSpeed
TDMBusOutputPort
TDMBusOutputStartingChannel
Version SN09
Table 12-3: Infrastructure Parameters
Description
When using H.110/H.100 bus, this
parameter also selects the trunk
used as the clock source for the
NetRef clock generation (in this case,
the clock source must not be set to
Network.
Range = 0 to (MAX_TRUNK _NUM-
1)
Set SC/MVIP/H.100/H.110 to either:
0 = Slave mode (another board in the
system must supply the clock to the
TDM bus) or Master mode (the board
is the clock source for the TDM bus)
or Secondary Master mode (for
H100/H110 Bus only).
1 = H.110A Master in Master mode
2 = H.110B Master
Selects the NetRef output
functionality.
0 = Do not output any NetRef
1 = Generation of NetRef 1
2 = Generation of NetRef 2
3 = Generation of both
Determines the NetRef frequency (for
both generation and
synchronization).
0 = 8 kHz
1 = 1.544 MHz
2 = 2.048 MHz
Defines the SC/MVIP/H.100/H.110
output port to be used for the board's
channel #0. All other channels then
occupy the next timeslots
sequentially.
Range:
0 to 15 for SC/MVIP
0 to 31 for H.110
Defines the outgoing TDM Timeslot
for board's channel #0. The
remaining channels are organized
sequentially.
253
12. Appendix - Individual ini File Parameters
Host/Manual
Default Value
Valid
Range
0 0 to 2
0 0 to 3
0 0 to 2
0 See
Descr.
0 0 to 127
October 2006