Nortel Media Gateway 3200 User Manual page 270

ini File Field Name
RTCPInterval
SingleSIDPacketWithSCEG72
9
TransactionIDBase
TransactionIDRange
TransparentCoderPayloadType Alternative payload type to use as
TrunkName
USETransparentCoderWithHB
R
User's Manual
Table 12-6: Common Control Parameters
Description
Transaction Id Range and Transaction
ID Base.
Defines the time interval between the
adjacent RTCP reports, in msec.
When using a G.729 coder connection
and SCE (Silence Suppression
Enable) is On, a single SID packet is
sent.
If set to 1 and the channel was
opened or modified to operate with the
G.729 coder with Silence Suppression
when Silence is detected, only a
single SID packet is sent.
If set to 0, SID packets are sent
frequently, according to energy
changes that require a SID packet for
each change.
Defines the minimum number for the
transaction ID.
Defines the range for the transaction
ID.
Default = 999999999
transparent coder.
(H.248) Prefix of the trunk part of the
termination name.
Range: String[19]
Default:
H.248 = ' ' for analog boards and 's' for
trunking boards
If this parameter is set to 1 and the
connection uses HBR (High Bit Rate)
coders, the DTMF transport type is set
to Transparent.
Coders list:
G711A-law_64, G711 µ-law,
G726_16, G726_24, G726_32,
G726_40, G727_16, G727_24_16,
G727_24, G727_32_16, G727_32_24,
G727_32, G727_40_16, G727_40_24,
G727_40_32.
0 = Do not use; 1 = Use
270
MG 3200
Host/Manual Valid
Default Value Range
5000 0 to 65535
0 0 or 1
2000 > 0
See Descr. > 0
116 0 to 127
See Descr. See
Descr.
0 0 or 1
Document # LTRT-72704