Connecting A Cable Between A Modem And A Device - Nortel Multiservice Switch 7400 Installation & Maintenance

Connecting a cable between a modem and a device

Connect a cable between a modem and a device after you have configured
the modem software.
Prerequisites
Ensure that the cable complies with all of the specifications contained in
Modem cable specifications (page
Procedure steps
Step
1
2
3
4
5
Copyright © 2005, Nortel
- 145 -
Hardware procedures
Action
Plug the 9-pin connector on the cable into the port 1 connector on the
faceplate of the CP. See the figure
Route the other end of the cable through the cable organizer to the rear of
the device.
If the device is in a cabinet, place the modem at the rear of the device. Find
a way to fasten it to the cable guide on the side that is nearest to where the
cable passes over the top of the shelf.
Plug the modem into a dedicated power outlet. Follow the instructions
provided by the manufacturer of the modem.
Plug the other end of the into the appropriate port on the modem. Follow the
instructions provided by the manufacturer of the modem.
Nortel Multiservice Switch 7400
Hardware Installation, Maintenance, and Upgrade
NN10600-175 7.1S1 Standard
PCR7.1 and up October 2005
108).
Control processor faceplate (page
--End--
146).
Nortel Confidential