Multiport Aggregate Device Replacement - Nortel Multiservice Switch 7400 Installation & Maintenance

Multiport aggregate device replacement

Replace a multiport aggregate device to enable a 32-port E1 TDM FP to
deliver configured services.
Prerequisites to multiport aggregate device replacement
Multiport aggregate device replacement task flow
This task flow shows you the sequence of procedures you do to replace a
multiport aggregate device. To link to any procedure, go to
navigation (page
Multiport aggregate device replacement task flow
Multiport
aggregate
device
replacement
Locking a port
Copyright © 2005, Nortel
CAUTION
Service loss on active ports
Replacing a multiport aggregate device requires you to remove all
the E1 ports connected to the device from service for the duration of
the replacement. Minimize the impact of the outage by rerouting
traffic to other nodes in the network before locking the ports.
113).
Installing a
Removing a
multiport
multiport
aggregate device
aggregate device
Nortel Multiservice Switch 7400
Hardware Installation, Maintenance, and Upgrade
NN10600-175 7.1S1 Standard
PCR7.1 and up October 2005
Task flow
Unlocking a port
End
PP_TASK_1019.ins
Nortel Confidential