Unpacking A Processor Card - Nortel Multiservice Switch 7400 Installation & Maintenance

Unpacking a processor card

Unpack a processor card in preparation for installation. Nortel Networks packs
processor cards separately, in boxes that contain antistatic material.
Prerequisites
Procedure steps
Step
1
2
Copyright © 2005, Nortel
- 469 -
Hardware procedures
CAUTION
Risk of electrostatic damage
When handling processor cards, wear a grounded antistatic wrist
strap so that you do not damage electronic parts. For more
information, see Avoiding damage from static electricity (page
CAUTION
Risk of service degradation by condensation
Condensation on a processor card can affect its ability to operate.
Allow an unpacked processor card at least one hour to adjust to the
ambient temperature and humidity of the room before inserting it into
a shelf.
Action
Open the box and remove the processor card. See the figure
protection for unpacking a processor card (page
Save the original packaging. You must use this packaging if you need to
store or ship the processor card.
Nortel Multiservice Switch 7400
Hardware Installation, Maintenance, and Upgrade
NN10600-175 7.1S1 Standard
PCR7.1 and up October 2005
470).
--End--
135).
Antistatic
Nortel Confidential