Table of Contents
Advertisement
50 Installing and connecting a WSS
Connecting to the network
Use the following procedures to connect a WSS to APs or other 10/100 Ethernet devices and to gigabit
Ethernet devices.
Connecting to an AP or other 10/100 Ethernet device
Note.
The 10/100 Ethernet ports are configured as wired network ports by default. You
must change the port type for locally connected APs, and for wired end stations that use
AAA through the WSS to access the network.
Figure 12
shows how to install a Cat-5 cable for a 10/100 Ethernet port. Refer to this figure as you perform the
procedure.
Figure 12.
10/100 Cat-5 Cable Installation
To connect to an AP or other 10/100 Ethernet device:
1
Insert a Cat-5 cable with a standard RJ-45 connector as shown in
•
For direct connection to an AP, use a straight-through cable.
•
For connection to a router or to an end station such as a PC, printer, or server, use a
straight-through cable.
NN47250-301 (320656-D Version 01.02)
Ethernet cable
(Cat 5 cable)
Ethernet port
AP, switch, server
or other device
Figure
12:
Advertisement
Table of Contents
Troubleshooting
