Connecting A Cable Between A Modem And A Device - Nortel 7400 Hardware Installation

Connecting a cable between a modem and a device

Prerequisites
Procedure steps
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Connect a cable between a modem and a device after you have configured the
modem software.
Ensure that the cable complies with all of the specifications contained in
"Modem cable specifications" (page 175).
1 Plug the 9-pin connector on the cable into the port 1 connector on the
faceplate of the CP. See the figure "Control processor faceplate"
(page 220).
2 Route the other end of the cable through the cable organizer to the rear
of the device.
3 If the device is in a cabinet, place the modem at the rear of the device.
Find a way to fasten it to the cable guide on the side that is nearest to
where the cable passes over the top of the shelf.
4 Plug the modem into a dedicated power outlet. Follow the instructions
provided by the manufacturer of the modem.
5 Plug the other end of the into the appropriate port on the modem. Follow
the instructions provided by the manufacturer of the modem.
Chapter 39 Hardware procedures 219