Installing A Shelf Interconnect Cable - Nortel Multiservice Switch 7400 Installation & Maintenance

Installing a shelf interconnect cable

Install a shelf interconnect cable so that you can monitor the alarm status of
two Nortel Multiservice Switch 7480s using a single external alarm.
Prerequisites
• Follow
unit from damage by ESD or from transferring ESD to other hardware.
Procedure steps
Step
1
Copyright © 2005, Nortel
- 232 -
Hardware procedures
Avoiding damage from static electricity (page 135)
Action
Connect the interconnect cable to the Alarm 2 connector on the rear of each
of the shelf assemblies as shown in the figure
interconnection between two Multiservice Switch 7480s (page
If one or both shelves are already powered up when the cable is connected,
any alarms that have been generated will be reported to the CP.
Nortel Multiservice Switch 7400
Hardware Installation, Maintenance, and Upgrade
NN10600-175 7.1S1 Standard
PCR7.1 and up October 2005
Dual alarm shelf
--End--
to protect the
373).
Nortel Confidential