Removing A Multiservice Switch Cabinet From A Pallet - Nortel Multiservice Switch 7400 Installation & Maintenance

Removing a Multiservice Switch cabinet from a pallet

After you unpack the Nortel Multiservice Switch cabinet, remove it from its
pallet. If the cabinet is the seismic version, see the procedure
removing a seismic cabinet from a pallet (page
Prerequisites
Procedure steps
Step
1
2
3
Copyright © 2005, Nortel
- 366 -
Hardware procedures
WARNING
Risk of personal injury
A cabinet that contains one device weighs 200. kg (441 lb). You need
four people to move this cabinet.
A cabinet that contains two devices weighs 313. kg (689 lb). You
need six people to move this cabinet.
WARNUNG
Verletzungsgefahr
Ein Gehäuse mit einem Switch wiegt 200 kg. Zum sicheren Bewegen
dieses Gehäuses werden vier Personen benötigt.
Ein Gehäuse mit zwei Switches wiegt 313 kg. Zum sicheren
Bewegen dieses Gehäuses werden sechs Personen benötigt.
CAUTION
Avoid structural stress when maneuvering uncrated
cabinets and shelf assemblies
When handling and moving uncrated cabinets and shelf assemblies,
avoid strain, excessive shock, or vibrations, which can damage or
warp the equipment.
Action
Remove and keep the packing slips and shipping papers attached to the
outside packaging.
Ensure that the pallet is on a flat surface.
The anchor brackets fasten the cabinet to the pallet with lag bolts. Use an
open-end wrench or socket wrench to loosen the lag bolts. The figure
Unanchoring a cabinet from a pallet (page 368)
cabinet and a close-up of an anchor bracket.
Nortel Multiservice Switch 7400
Hardware Installation, Maintenance, and Upgrade
NN10600-175 7.1S1 Standard
PCR7.1 and up October 2005
Unpacking and
475).
shows the top view of the
Nortel Confidential