Installing The Replacement Switch Module; Reconfiguring The Replacement Switch Module; Figure 3-9. Removing The Module From The Centillion 50/100 Chassis - Nortel Centillion EtherSpeed II Using Manual

Using the Centillion EtherSpeedII Switch Modules
Slide the switch module out of the chassis
5.
Hold the front panel with one hand while you support the bottom of the switch
module with the other hand.
Figure 3-9.
Place the switch module on an antistatic mat until you are ready to put it
6.
back into the chassis.
If you are not installing another switch module of the same model, install
7.
a filler panel over the empty slot.

Installing the Replacement Switch Module

To install the replacement switch module, follow the procedure described in
"Installing a Switch

Reconfiguring the Replacement Switch Module

The EtherSpeedII 10/100BASE-T and the EtherSpeedII 100BASE-FX switch
modules keep the configuration of an identical replacement module. If the
replacement is not of the same model type, you must reconfigure the module after
it is replaced. Follow the procedure described in
Modules" on
3-10
Removing the Module from the Centillion 50/100 Chassis
Module" on page
page 3-2.
Get other manuals https://www.bkmanuals.com
(Figure 3-9).
3-2.
"Checking LEDs on the Switch
6471
207344-B