Table of Contents
Advertisement
Chapter 6
Contivity 4500 option installation
This section describes how to install or replace hardware components for the
Contivity 4500.
Opening the Contivity 4500
To replace power supplies and hard disk drives, or to access the diskette drive for
system recovery operations, you must remove the front bezel from the Contivity
4500. To install LAN or WAN cards, or to install additional memory, you must
remove the front bezel and the top cover from the Contivity 4500.
The first few times that you remove the front bezel it will be somewhat difficult to
remove. This is because the ball stud and sockets are new. After a few times,
removal is easier.
Warning: Wear an antistatic band when handling electronic
components for the Contivity 4500 to avoid damaging them.
Danger: Make sure to turn off the Contivity 4500 and unplug it before
you attempt to install option cards or system memory.
Note: Removing the front bezel on the Contivity 4500 activates the
chassis intrusion alarm only if the gateway is turned on. The intrusion
alarm is reported to the system log file.
Installing Hardware Options for the Contivity Secure IP Services Gateway
81
Advertisement
Table of Contents
