Figure 27 Location Of Option Card Slots And Dimms On The System Board - Nortel Contivity 600 Installing

4
Lift the lid 2 or 3 inches and pull it off the chassis.
The system board is now exposed.
card slots and the DIMMs on the system board.
Contivity 2600, but the Contivity 2700 is very similar.)

Figure 27 Location of option card slots and DIMMs on the system board

DIMMs
Warning: Beware of danger if battery is incorrectly replaced. Replace
with the same or an equivalent battery only, as recommended by the
manufacturer's instructions.
Danger: In spite of the above warning, which is mandated for
regulatory approval, you should not change the battery. If you suspect a
dead battery, contact Nortel Networks Customer Support.
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 5 Contivity 2700 and 2600 option installation 71
Figure 27
1
2
1 2
shows the location of the option
(Figure 27 shows the
4 option card slots
3 4
CS260008A