Table of Contents
Advertisement
11 With two people facing the front of the equipment rack, set the Contivity 5000
on the rack-mount shelf.
12 Insert one of the 1/2-in. truss screws through the bottom hole on each side of
the shelf into the hole in the rack and tighten the screws.
13 Replace the front bezel (see
a
b Using the screwdriver, tighten the 2 screws to secure the bezel to the
Replacing a power supply
The Contivity 5000 ships with dual hot-swappable 350 W power supplies installed
in the chassis. The power supplies share the load of providing power to the
Contivity 5000. If one power supply fails, the second one provides all the power
required by the gateway.
The power supplies are accessible from the rear of the chassis
Figure 53 Location of the Contivity 5000 power supplies
LEDs
Hold the bezel by its two handles and push it onto the chassis.
chassis.
10893EB
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 8 Contivity 5000 option installation 119
Figure 51 on page
116).
(Figure
53).
Advertisement
Table of Contents
