Removing the front bezel and top cover
To install option cards or DIMMs, you must remove the front bezel and the top
cover from the gateway.
To remove the front bezel:
1
Shut down the Contivity 2700 or 2600 using the Web GUI or the command
line interface and then unplug it as described in
add or replace hardware" on page
2
Using a Phillips screwdriver, turn each of the 2 screws on the front bezel a
quarter turn counterclockwise
Figure 25 Removing the front bezel
3
Grip the two handles and firmly pull the bezel toward you to unsnap it from
the chassis.
Chapter 5 Contivity 2700 and 2600 option installation 69
Danger: Make sure to turn off the gateway and unplug it before you
attempt to install an option card or DIMM.
Caution: Do not use the piece with the Nortel Networks logo and the
LEDs as a handle.
Installing Hardware Options for the Contivity Secure IP Services Gateway
"Shutting down the system to
68.
(Figure
25).
CS260015B