Table of Contents
Advertisement
Figure 17 Installing and removing a DIMM in a Contivity 1700 or 1600
Alignment keys
To remove DIMMs, pull back
locking levers and pull out DIMM.
To install DIMMs, pull back locking
levers and push in DIMM.
10 Replace the top cover on the chassis (see
a
Hold the cover at an angle and slide it onto the chassis.
b Using a screwdriver, insert and tighten the 4 screws to secure the cover to
the chassis.
11 If the gateway is installed in an equipment rack, mount it in the rack.
a
Set the Contivity 1700 or 1600 on the rack-mount shelf in the rack.
b Insert one of the panhead screws through the bottom hole on each side of
the shelf into the hole in the rack and tighten the screws.
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 3 Contivity 1700 and 1600 option installation 51
Locking lever
CS160008A
Figure 11 on page
42).
Advertisement
Table of Contents
