Nortel Contivity 600 Installing page 115

6
Remove the filler panel screw and pull out the filler panel (or the option card
that you are replacing) from the slot
7
Lower the new option card into the slot connector and gently press the option
card into the connector.
Make sure that the card is seated firmly in the slot. If the card is not seated
properly, it will not work.
Figure 50 Installing and removing an option card
Option card
Motherboard
8
Replace the screw that secures the card to the slot
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 8 Contivity 5000 option installation 115
(Figure 50).
Rear of unit
Option card slots
Filler panel screw
CS2600017B
(Figure 50).