Replacing A Power Supply; Figure - Nortel Contivity 600 Installing

100 Chapter 7 Contivity 4600 option installation
Figure 43 Installing Contivity 4600 DIMMs
7
Pull up the locking levers on both sides of the next available DIMM, and snap
the DIMM into its socket.
8
Replace the support bracket by tightening the two secured captive screws and
the rear Phillips screw.
9
Push in the slide-out tray and tighten the thumb-screws.

Replacing a power supply

To remove the power supply:
1
Remove the front bezel as shown in
2 Use a flat-head screwdriver to unscrew the top and bottom power supply
screws, as shown in
302283-K Rev 00
Alignment
Keys

Figure

44.
1
2
2
3
4
Locking lever
Figure 39.
CS460009A