Figure 11 Removing The Top Cover - Nortel Contivity 600 Installing

42 Chapter 3 Contivity 1700 and 1600 option installation
The first few times that you remove the front bezel, it may be somewhat
difficult to remove because the ball studs and socket clips are new.
To remove the top cover:
1
If the gateway is installed in an equipment rack, remove it from the rack.
a
b Remove the Contivity 1600 or 1700 from the rack-mount shelf and set it
2
Using a Phillips screwdriver, remove the 4 screws that secure the cover to the
chassis

Figure 11 Removing the top cover

3
Slide the top cover forward approximately 1/4 inch.
302283-K Rev 00
At the front of the chassis, remove the 2 panhead screws that secure the
bottom of the chassis to the equipment rack.
on a sturdy surface.
(Figure 11).
Remove these 4 screws
Alert/Firm
Boot/Ready
Slide cover forward and lift up
CS160003A