Table of Contents
Advertisement
Figure 45 Removing a Contivity 4600 hard disk drive
Insert and turn key, then
remove hard disk by handle.
3
Insert the replacement hard drive fully, and lock it by turning the key
clockwise. Make sure the hard disk drive LED shows the proper drive number.
4
Replace the front bezel.
If you need to reload the software on the disk, see the information on using the
recovery diskette in the book Installing the Contivity 4600.
Software
Enable the Contivity 4600 by following these steps:
1
Use your Web browser to navigate to the gateway, and go to the Admin > File
System display.
2
Click on the drive and click the Enable button.
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 7 Contivity 4600 option installation 103
Drive 0
Drive 1
CS460011A
Advertisement
Table of Contents
