Removing The Contivity 1600 Front Bezel; Figure 29 Removing The Contivity 1600 Front Bezel - Nortel 2500 Installation Hardware

68 Chapter 5 Contivity 1600 Option Installation

Removing the Contivity 1600 front bezel

You must remove the bezel to insert the recovery diskette. Note that you do not
need to turn off the Contivity switch if you are only removing the front bezel.
Figure 29

Figure 29 Removing the Contivity 1600 front bezel

Note that the first few times you remove the front bezel it will be rather difficult to
remove. This is because the ball studs and socket clips are new. After a few times,
removal is easier.
To remove the front bezel you need a Phillips screwdriver.
1
Turn each of the two screws on the front bezel a quarter turn
counter-clockwise.
2 Grip the two handles and firmly pull the bezel towards you to unsnap it from
the chassis.
302283-E Rev 00
shows you how to remove the front bezel from the Contivity switch.
Warning: When handling the Contivity switch outside of the
rack-mount shelf, do not use the part labeled with the Nortel Networks
logo and the LEDs as a handle.
CS160014A