Replacing A Power Supply - Nortel 2382 Configuration Manual

52 Installing and connecting a WSS

Replacing a power supply

1
Remove the power cord from the power supply.
2
Loosen the thumbscrew using a #2 Phillips-head screwdriver as shown in
3
Use the handle to pull the power supply partway out of the slot as shown in
Caution!
WSS. If the rear of the power supply is not supported, the supply will fall when you
remove it, possibly damaging the rear components of the supply.
Figure 11. Removing a Power Supply from a 2380 Switch
4
Place your other hand under the supply to support it and remove the supply the rest of the way
out of the slot.
5
Go to step 3
NN47250-301 (320656-E Version 02.01)
Support the bottom of the power supply while removing it from the
of "Installing a new power supply" on page
Loosen
thumbscrew
51.
Figure 11.
Figure 11.