Nortel HomeOffice II User Manual page 153

July 1999
4 Configure the time kept by the HLC according to the following table.
IF you wish to
keep the time currently
maintained by the HLC
change the time maintained
by the HLC
Note: Information configured through the above steps has not yet been
saved and is currently stored only in RAM. If the board were to be removed
or the power turned off, the information would be lost.
5 If you wish to save the information, enter PROVISION SAVE, or P S and
press Enter. See "PROVISION SAVE (P S)" on page 149.
Line Card Configuration Guide
THEN
press Enter.
type the time in 24-hour HH:MM:SS
format
and press Enter.
Result: A message similar to the
following appears:
Current Time 17:55:05
Maintenance
135