Table of Contents
Advertisement
Software configuration
To configure voice and data ports
Because this is a switch configuration procedure, the exact procedures will be
contained in documentation for your particular switch. The first step in port
configuration on any switch, however, is accessing the Host SDI connection.
Note: The HLCs should be in their card slots while completing voice and data
port configuration.
1
If you are not already logged in to the system, log in to the MMI. See
"LOGIN (L)" on page 91.
Result: The HLC command prompt appears as shown on page 91.
2
Enter the HOST command to access the SDI connection. See "HOST
(HO)" on page 94.
Result: After you complete the sequence outlined on page 94, the switch
presents you with a "CONNECTED" message.
3
Complete voice and data port configuration as per the documentation for
your particular switch.
Log out of the switch's SDI connection by entering the HOST logout
4
command, @@@, once correct configuration is confirmed.
80
Standard 01.02
Meridian HomeOffice II
Advertisement
Table of Contents
