Table of Contents
Advertisement
July 1999
To set the characteristics of the telephones on a channel
1
If you are not already logged in, log in to the MMI.
See "LOGIN (L)" on page 91.
Result: The MMI presents you with the logged-on command prompt.
See "Command prompts" on page 91.
2
At the command prompt, type SET PHONE or S P and press Enter.
Result: The MMI's prompt for the channel for which you want to set
telephone characteristics is similar to the following figure:
Mon, 05-17-1999
HLC::>s p
Enter
<Channel>
3
Configure the properties of a channel's telephones according to the
following table.
IF
the remote
telephone is
cordless
the remote
telephone is
corded
Line Card Configuration Guide
18:05:20
THEN type
the number of the channel for which you want to
configure telephone characteristics and press Enter.
Result: A message similar to the following appears:
Cordless Phone Attached (YES or NO)
Type YES and press Enter.
Result: A message similar to the following appears:
Channel 6: Cordless phone attached
Indicator Update Mode Enabled
Note: Indicator Update Enabled may
increase phone charges.
the number of the channel for which you want to
configure telephone characteristics and press Enter.
Result: A message similar to the following appears:
Cordless Phone Attached (YES or NO)
Type NO and press Enter.
Result: A message similar to the following appears:
Indicator Update Mode (ENABLE or
DISABLE)
Maintenance
129
Advertisement
Table of Contents
