Nortel HomeOffice II User Manual page 191

July 1999
IF the remote
numbers
don't agree
4 If the problem persists, check the appropriate settings at the switch.
To check settings on the switch
1 If you are not already logged in, log in to the MMI.
See "LOGIN (L)" on page 91.
Result: The MMI presents you with the logged-on command prompt.
(See "Command prompts" on page 91.)
2 At the command prompt, type HOST or HO and press Enter.
Result: The MMI prompts you for a password.
Note: The non-configurable password is "HOST."
3 You must type the case-sensitive password in all uppercase letters and
press Enter.
Result: Five asterisks, one for each letter of the password and one for the
Enter keystroke, and the word "CONNECTED" appear, similar to the
following figure:
Wed, 05-26-1999
HLC::>HO
Enter Password *****
4 Refer to documentation specific to your particular switch for appropriate
troubleshooting procedures.
Line Card Configuration Guide
THEN
do the following:
Reconfigure the remote site's remote number
to agree with the Line Card Ports Configuration
form mentioned in the previous step. See the
Meridian HomeOffice II Network Administration
Guide (NTP 555-8321-310) for the proper
procedure.
Check for blocked calls.
17:17:34
Troubleshooting
173