Table of Contents
Advertisement
July 1999
2
At the command prompt, type DISPLAY CONFIG or D C and press Enter.
Result: The MMI displays the configuration settings for the HLC. The on-
screen display is similar to the following figure
Wed, 05-26-1999
HLC::>d c
HLC S/N: NNTM183vedat 04
Firmware Version: D1.15d1 FLASH
16 Port Echo Cancellation
Init: Sun, 01-30-2000
Slot Position: 6
Site Name:
Security Level for Card: 1
Autoclock is Disabled
Dip Switch 1 (SW1) Settings
S6..S1: OFF OFF OFF OFF OFF OFF - Daisy Chain Address 00
S7:
OFF - MMI End
S8:
OFF - SDI End
Dip Switch 2 (SW2) Settings
S1:
OFF - 9600 Baud
S2:
OFF - N81
S3:
OFF - Allow Flash Execution
S4:
OFF - Meridian 1 Switch
S5..S8: OFF OFF OFF OFF - Unused
Wed, 05-26-1999
HLC::>
Line Card Configuration Guide
16:08:07
5:03:49
16:08:11
Maintenance
:
103
Advertisement
Table of Contents
