Table of Contents
Advertisement
Label Length
Set the length of one piece of the media used for the head check print.
The setting range is from 40 to 240 dots.
Pitch
Set the print position in the vertical direction.
The setting range is from -30 to +30 dots.
When you decrease the setting value, the print position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print position moves opposite the feed direction (toward
the end part of the media).
Offset
Set the stop position of the media.
The setting range is from -30 to +30 dots.
When you decrease the setting value, the stop position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop position moves opposite the feed direction (toward
the end part of the media).
Darkness Adjust
Fine tune the print darkness of the head check print.
The setting range is from 0 to 99.
0 is the lightest and 99 is the darkest.
•
You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
•
The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
•
The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[HEX-Dump]
Save the hex dump print data or dump data from the receive buffer to the USB memory.
The setting items are as follows:
[Hex Dump Mode]
Enable or disable the Hex Dump mode.
If you set the [Hex Dump Mode] to [Enabled], the product prints the received data and at the same
time creates a file of the received data inside "hexdump/".
•
If [Hex Dump Mode] is enabled, [HEX-Dump] appears on both the Online and Offline
screens.
225
Advertisement
Table of Contents
