Table of Contents
Advertisement
•
When the connection to the access point is failed, [Failed to find an Access Point.]
appears on the screen.
[PIN]
Set the wireless LAN connection using the PIN code method.
1. Select [PIN] in the [Wi-Fi Protected Setup(WPS)] menu.
2. When [Scanning...] appears on the screen, set the PIN code shown on the screen to the access
point of the wireless LAN or computer.
3. When the connection to the access point is established, [Successfully configured.] appears on the
screen.
•
If the connection to the access point is failed, [Failed to find an Access Point.] appears
on the screen.
[Wi-Fi Direct]
Set the Wi-Fi Direct function.
The Wi-Fi Direct function is enabled if you have selected [Infrastructure] in the [Mode] menu. If you
have changed the setting from [Ad-hoc] to [Infrastructure] in the [Mode] menu, reboot the product
before setting the Wi-Fi Direct function.
The setting procedure is as follows:
1. Set the device name for the product using [Device Name]. You can enter 1 to 32 characters.
Alphabets (capital and small letters), numbers and symbols can be used.
2. Select [Connect] to search and show the connectable device names or to accept connection
requests when the product is the GO (Group Owner).
3. Select [Start Group] if you want to start a new persistent group or select a group from the list.
4. Select [Remove Group] to remove the persistent group in step 3.
5. Complete the connection according to the display on the product or device you want to connect.
6. Select [Disconnect] if you want to stop the connection.
•
You can connect a maximum of 10 devices.
•
When Wi-Fi Direct is active, [Device Name] cannot be changed.
•
[Start Group] and [Remove Group] are shown only if Wi-Fi is active and the product is
not connected to a Wi-Fi Direct network.
•
After setting up a start group, the product will be set to the GO (Group Owner) and will
wait for a connection request from another device.
•
If the product is powered off during a persistent group connection, the group will be
started automatically after the product is powered on.
[Band]
Set the Band.
167
Advertisement
Table of Contents
