Table of Contents
Advertisement
•
You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
Adjusting Direction of the Print Reference Position and Base Reference Point
(1) Feed direction
(2) Liner
(3) Label
(4) Gap between labels
(5) Print reference position (before correction)
(6) Adjustment of vertical base reference point
(7) Adjustment of horizontal base reference point
(8) Base reference point after adjustment
[Advanced]
Set detailed sensor operation and print motion.
The available setting items are as follows.
[Calibrate]
Adjust the media sensor level.
In instances of media detection malfunction, adjust the media sensor level (Gap and I-mark sensors).
The setting items are as follows:
[Auto-calibration]
Perform the auto-calibration for the selected media sensor.
147
Advertisement
Table of Contents
