Table of Contents
Advertisement
[Tear-Off] (Function that feeds the printed media to the tear-off position)
After printing the specified number of media, the product feeds the last printed media so that it
is fully extended out of the product's front for removal. After printing, tear off the media manually.
The media will be back to the print head position for starting the next printing.
[Dispenser]
Peel the liner from the printed label as the label is fed to the product's front. Once the printed
label has been removed from the product, the next label is positioned for printing.
[Linerless tearoff]
The product feeds each printed media so that it is fully extended out of the product's front for
removal. After printing, tear off the media manually. The media will be back to the print head
position for starting the next printing.
Select this when using a linerless label on a linerless model.
6. Select the sensor type for detecting the media.
[None]
Disable the media sensor.
[Gap]
Select when using the media of Gap type. Use the transmissive sensor.
[I-Mark]
Select when using the media of I-mark type. Use the reflective sensor.
•
The available selections vary depending on the [Print Mode] set on the product. The
default value for [Print Mode] is [Tear-Off].
◦
If [Print Mode] is set to [Dispenser], only [Gap] and [I-Mark] will be available.
◦
If [Print Mode] is set to [Linerless tearoff], only [None] and [I-Mark] will be available.
7. Load the media while checking the video.
96
Startup Guide Flow
Advertisement
Table of Contents
