Table of Contents
Advertisement
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 76.2 mm (3") for [Large].
Pitch
Set the print position in the vertical direction.
The setting range is from -45 to +45 dots.
When you decrease the setting value, the print position moves in the feed direction.
When you increase the setting value, the print position moves opposite the feed direction.
Offset
Set the tear-off position/cut position/dispense stop position.
The setting range is from -45 to +45 dots.
When you decrease the setting value, the stop position moves in the feed direction.
When you increase the setting value, the stop position moves opposite the feed direction.
Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
•
The length of 1 dot is 0.083 mm (0.0033").
•
You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
•
The value of [Pitch], [Offset] and [Darkness Adjust] set in the [BD address] will be
reflected to the same item settings in the [Factory] menu, [Configure List] menu,
[Configure QR] menu and [Paper Sensor] menu.
[HEX-Dump]
Save the hex dump print data or dump data from the receive buffer to the USB memory.
The setting items are as follows:
[Hex Dump Mode]
Enable or disable the Hex Dump mode.
If you enable [Hex Dump Mode], the printer prints the received data and at the same time creates a file
of the received data inside "hexdump/".
If you return the setting to disabled, you can check the file on the screen.
297
Advertisement
Table of Contents
