Warning Labels - Epson LS-B Series Manual

LS20-B Manipulator 1. Safety

1.8 Warning Labels

The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain the
Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the nearby
areas.
Location
A
B
C
D
E
F
134
Warning Label NOTE
Before loosening the base mounting screws,
hold the arm and secure it tightly with a band
to prevent hands or fingers from being
caught in the Manipulator.
Do not enter the operation area while the
Manipulator is moving. The robot arm may
collide against the operator.
extremely hazardous and may result in
serious safety problems.
Hazardous voltage
Manipulator is ON. To avoid electric shock,
do not touch any internal electric parts.
You can catch your hand or fingers
between the shaft and cover when bringing
your hand close to moving parts.
* Manipulators with bellows do not have this
label since there is no danger of being your
hand or fingers caught.
Before loosening the base mounting screws,
hold the arm and secure it tightly with a band
to prevent hands or fingers from being
caught in the Manipulator.
Only authorized personnel should perform
sling work and operate a crane and a
forklift.
When these operations are performed by
unauthorized personnel, it is extremely
hazardous and may result in serious bodily
injury and/or severe equipment damage to
the robot system.
This is
exists while the
LS-B series Rev.5