Canon PIXMA MG4200 Series On-Screen Manual page 905

or tape if it is attached to the
holder.
- The card is currently writable
from PC.
Set to [Not writable from PC].
- Power was not turned off
correctly the last time.
Press the
turning power off.
4100 Cannot print the data.
- Cannot connect to the server.
Please wait a while and try
again.
the tape remains attached.
Check the inside of the machine. If the protective
material or the tape remains attached, remove it.
The card slot is set to Writable from USB PC or
Writable from LAN PC.
You cannot print from the memory card or save the
scanned data to the memory card when the card
slot is set to Writable from USB PC or Writable
from LAN PC. After writing on the memory card,
select Not writable from PC in Read/write
attribute under Device user settings.
The power cord may have been unplugged last
while the machine was still on.
Press the OK button to dismiss the error.
button when
Note
See
unplugging the power cord.
When you print the contents on CREATIVE PARK
PREMIUM, confirm the message on the computer
screen, make sure that genuine Canon FINE
cartridges are all installed properly, then start
printing again.
You cannot connect to the server due to some
communication error. When you have tried to
access a photo sharing site, it is possible that your
photos have been deleted.
Press the OK button to dismiss the error, then try
again after a while.
Notice for Unplugging the Power Cord for
Page top