Canon PIXMA MG4200 Series On-Screen Manual page 898

B200 An error has occurred.
The printer needs repair.
Follow the steps below.
1. Turn the device off and unplug
the power cord from the power
supply.
2. See the manual and contact
the service center.
5100 Printer error has occurred.
Follow the steps below.
1. Cancel printing, then turn the
device off.
2. Remove any foreign objects
from the paper output slot, rear
side and inside of the device.
3. Make sure that the ink tanks
or ink cartridges are installed
correctly.
4. Turn the device on again.
If problem persists, see the
manual and contact the service
center.
Printer error has occurred.
5011
5012 Follow the steps below.
5200 1. Cancel printing, then turn the
5400 device off.
6000 2. Turn the device on again.
6800 If problem persists, see the
6801 manual and contact the service
6900 center.
6901
6902
6910
6911
6930
6931
6932
6933
6934
6935
6936
6937
6938
6940
6941
6942
6943
6944
6945
6946
1890 Remove the protective material
status of the print head.
Printing the Nozzle Check Pattern
If the error is not resolved, connect the machine to
the computer and align the print head on the printer
driver.
Aligning the Print Head Position from Your
Computer
Turn off the machine, and unplug the power cord of
the machine from the power supply.
Contact the service center.
Cancel printing, and turn off the machine. Then
clear the jammed paper or protective material that
is preventing the print head holder from moving,
and turn on the machine again.
Important
Be careful not to touch the components inside
the machine. The machine may not print out
properly if you touch it.
If the problem is not resolved, contact the
service center.
Turn off the machine, and unplug the power cord of
the machine from the power supply.
Plug the machine back in and turn the machine
back on.
If the problem is not resolved, contact the service
center.
The protective material for the FINE Cartridge or