Teledyne T3MIL50 User Manual page 81

D.c. milli-ohm meters
Table of Contents

Advertisement

3. Channel setting
4. Delay setting
5. Start the scan.
Note
Range
Abs, △%
The Channel setting sets the number of DUT channels
that are used.
Use the arrow keys to navigate to the Channel setting and
press Enter.
Use the left and right arrow keys to select a digit. Use the
up and down arrow keys to edit the value of the selected
digit. Press Enter to confirm the setting.
Channel Range:
The Delay setting adds a pause between each channel
measurement.
The Use the arrow keys to navigate to the Delay setting
and press Enter.
Use the left and right arrow keys to select a digit. Use the
up and down arrow keys to edit the value of the selected
digit. Press Enter to confirm the setting.
400ms ~ 30000ms
Delay Range:
Press the
Trigger
Trigger pin of the SCAN interface port to start a scan
test.
See page 59 to set the external trigger edge as a rising or
falling leading edge.
HANDLER/SCAN INTERFACE
Channel setting
01 ~100
Delay setting
key or input a pulse signal on the
Move
and edit
Select and
Enter
confirm
Move
and edit
Select and
Enter
confirm
81

Advertisement

Table of Contents
loading

This manual is also suitable for:

T3mil50x

Table of Contents