Teledyne T3MIL50 User Manual page 80

Display Overview
1. Select the Scan
function
2. Select the
compare mode
80
The △% compare function compares the deviation of
the measured value from the reference value as a
percentage.
{ [(Measured Value-Reference)/Reference]%}.
A measured value that falls within the upper and lower
limits is considered IN (pass), a value that falls below the
lower limits is considered LO, and a value that falls over
the upper limit is a HI.
Lower
limit
LO
For both scan modes, the IN, HI or LO will be shown on
the display for each judgment (if the time between each
judgment is not too fast).
Scan function
Ready to start scan message
indicator
Reference, limits, scan mode, current
channel, measurement delay
Press Scan to access the scan mode, as shown
Scan
above.
Use the arrow keys to navigate to the Mode setting. Press
the Enter key to toggle the compare mode.
T3MIL Series User Manual
Reference Upper
value limit
IN HI
Change
display view
Enter
Mode
Move
Toggle