Toshiba e-STUDIO5540C Service Manual page 91

[EA28] Paper transport jam in Finisher (paper holding delay)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Paper holding cam
Assist arm motor (M10)
Finisher controller board
Replace parts
Assist arm motor (M10)
Finisher controller board
[EA29] Paper transport jam in Finisher (paper stack transport delay)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Buffer tray
Buffer tray guide motor (M2)
Finisher controller board
Replace parts
Buffer tray guide motor (M2)
Finisher controller board
[EA31] Transport path paper remaining jam
Classification
Finisher jam
(Finisher section)
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
[MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Is there any mechanical problem when the paper holding
cam is rotated?
• Motor check
• Connector check
• Harness check
• Connector check(CN13)
• Board check
[MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Is there any mechanical problem when the buffer tray
guide is opened and closed while the buffer roller is kept
raised?
• Motor check
• Connector check
• Harness check
• Connector check(CN11)
• Board check
The paper which has passed through the inlet sensor does
not reach the transport sensor. [MJ-1103/1104]
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 90
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item