Toshiba e-STUDIO5540C Service Manual page 113

Check item
LCF end fence home position sensor •
LCF end fence stop position sensor
PFC board
Replace parts
LCF end fence motor
LCF end fence home position sensor
LCF end fence stop position sensor
PFC board
[C1C0] Option LCF tray-up motor abnormality
Classification
Paper feeding system related service
call
Check item
Option LCF hook
Gaps between the equipment and
the optional LCF
Option LCF tray-up motor
Option LCF tray-up sensor
LCF board
PFC board
Replace parts
Option LCF bottom sensor
Option LCF top sensor
LCF board
PFC board
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Sensor check
(Perform the input check: 03-[COPY]ON/[9]/[E])
• Connector check
• Harness check
• Sensor check
(Perform the input check: 03-[SCAN]ON/[1]/[E])
• Connector check
• Harness check
• Connector check (CN507)
• Board check
The option LCF tray-up motor is not moving normally
Check that the optional LCF is hooked by two positions on the
equipment.If it is not hooked securely, perform its height
adjustment.
Check that the gaps between the equipment and the optional
LCF on the upper and lower positions are even.
If the gap on the upper position is wider than that on the lower
position, perform height adjustment of the optional LCF.
• Motor check
(Perform the output check: 03-270)
• Connector check
• Harness check
• Sensor check
(Perform the input check: 03-[SCAN]ON/[5]/[H])
• Connector check
• Harness check
• Connector check
• Board check
• Connector check (CN503)
• Harness check
• Board check
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 112
Measures
Remarks
Error item
Measures
Remarks