Toshiba e-STUDIO5540C Service Manual page 313

8.5.14 Skew (slantwise copying)
Cause/Section Step
Drawer/LCF 1
2
3
4
Paper feed 5
roller
Rollers 6
Aligning 7
amount
Registration 8
roller
Registration 9
guide
2nd transfer 10
front guide
RADF 11
Transfer unit 12
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Check item
Is the drawer or LCF properly
installed?
Is too much paper loaded in the
drawer or LCF?
Is the paper corner folded?
Are the drawer or LCF side guides
properly set?
Is the surface of paper feed roller
dirty?
Is each roller improperly fixed to the
shaft?
Is the aligning amount proper?
Is the registration roller spring
removed?
Is the registration guide improperly
installed?
Is the 2nd transfer front guide
installed properly?
Is the RADF installed and adjusted
properly?
Is the transfer belt unit installed
properly?
Fig.8-21
Reinstall the drawer or LCF properly.
Reduce paper to 550 sheets or less.
(Tandem LCF:
feeding side 1200 sheets or less/
stack,
standby side 1200 sheets or less/
stack)
Change the paper direction and
reinsert it.
Adjust the side guides.
Clean the roller surface with alcohol,
or replace the roller.
Check E-rings, pins and clips.
Increase the aligning amount.
Mount the spring correctly. Clean the
roller if it is dirty.
Correct it.
Correct it.
Reinstall and readjust it.
Correct it.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 312
Measures