Toshiba e-STUDIO5540C Service Manual page 320

Cause/Section Step
2nd transfer 12 Is there any abnormality on the cam,
contact/release pusher and actuator?
unit
(cam unit)
13 Is the 2nd transfer pressure reduction
operating correctly during Thick
paper printing?
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Check item
8 - 319
Measures
Check if the cam, pusher and
actuator are installed correctly and
there are no damages on them.
Repair or replace them if needed.
Invalidate the 2nd transfer pressure
reduction operation (change the
value from "1" to "0" for 08-4663.),
and check if the transfer failure is
cleared.
If it still persists, perform step 12
again.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8