Toshiba e-STUDIO5540C Service Manual page 102

Check item
Buffer tray guide
Buffer tray home position sensor (S5) •
Buffer tray guide motor (M3)
Finisher controller board
Replace parts
Buffer tray home position sensor (S5)
Buffer tray guide motor (M3)
Finisher controller board
[EF10] Selecting paper not supported by Saddle Stitch Finisher
Classification
Finisher jam (Finisher section)
Check item
Setting
Buffer tray home position sensor (S5) •
Buffer tray guide motor (M3)
Saddle controller board
Replace parts
Buffer tray home position sensor (S5)
Buffer tray guide motor (M3)
Saddle controller board
[EF11] Saddle Stitch Finisher stapling error (front)
Classification
Finisher jam (Saddle section)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Open and close the buffer tray guide. If there is any
mechanical problem, fix its mechanism.
Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check
• Board check
In the Saddle Stitch Finisher, selection is made of an
unsupported paper size and type and an excess number of
pages for stapling.
In the Saddle Stitch Finisher, selection is made of an
unsupported paper size and type and an excess number of
pages for stapling.
Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check
• Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 101
Measures
Remarks
Error item
Measures
Remarks
Error item
ERROR CODE and TROUBLESHOOTING
8