Repair Circuit Breaker Module - Graco Reactor 2 Repair Parts

4. Accept or cancel the hose calibration.
NOTE: NOTE: NOTE: A temperature estimate will be
displayed if the system was able to measure
the hose wire resistance.
Repair Repair Circuit Repair Circuit Circuit Breaker Breaker Module Breaker
1. Follow Before Beginning Repair, page
2. Using an ohmmeter, check for continuity
across the circuit breaker (top to bottom). If
no continuity, trip the breaker, reset, and
retest. If there still is no continuity, replace
the breaker as follows:
a. Refer to Electrical Schematics, page
b. Perform Shutdown, page
c. Refer to the circuit breaker identification
table and electrical diagrams.
d. Loosen the screws connecting the
wires to the circuit breaker that will be
replaced. Disconnect wires.
e. Pull the locking tab out 1/4 in. (6 mm)
and pull circuit breaker away from the
din rail. Install the new circuit breaker.
Insert wires and tighten down all screws.
334946J
Table 4 4 4 H H H - - - 30,
Table Table
Ref.
Ref. Ref.
853 (CB11) 50A, 1
854 (CB12) 20A, 2
855 (CB13) 40A, 2
855 (CB14) 40A, 2
855 (CB15) 40A, 2
Module Module
52.
Table 5 5 5 H H H - - - 40,
Table Table
Ref. Ref. Ref.
853 (CB11) 50A, 1
859 (CB12) 20A, 3
105.
854 (CB13) 60A, 2
50.
854 (CB14) 60A, 2
855 (CB15) 40A, 2
30, H H H - - - XP2 XP2 Circuit Circuit Breakers Breakers
30, XP2 Circuit Breakers
Size Size Size Compo- Compo- Compo-
nent nent nent
Heated
pole
Hose
Motor
pole
Heater A
pole
Heater B
pole
Trans-
former Pri-
pole
mary
40, H H H - - - 50, 50, H H H - - - XP3 XP3 Circuit Circuit Breakers
40, 50, XP3 Circuit
Size Component
Size Size Component Component
Heated Hose
pole
Motor
pole
Heater A
pole
Heater B
pole
Transformer
pole Primary
Repair
Part
Part Part
17A319
17A314
17A317
17A317
17A317
Breakers
Breakers
Part Part Part
17A319
17G724
17G723
17G723
17A317
69