Graco Reactor 2 Repair Parts page 21

Error Location
Error Error Location Location
ADM
F9FB
ADM
EVCH
EAUX ADM
EVSX HCM
EVUX ADM
H2MA Heater A
H2MB Heater B
Hose
H2MH
H3MA Heater A
H3MB Heater B
Hose
H3MH
L1AX ADM
334946J
Type Description
Type Type Description Description
Flow Cutback Low
Inlet B Pressure
Hose Manual Mode
Enabled
USB Busy
Standby
USB disabled
Low Frequency A
Low Frequency B
Low Frequency
Hose
High Frequency A
High Frequency B
High Frequency
Hose
Low Chemical Level
A
Cause Cause Cause Solution
Solution Solution
Resin inlet Increase resin feed pump
pressure is too pressure.
low
Resin inlet flow is Change to larger resin
too low feed pump.
Hose Manual Install a functioning fluid
Mode has been temperature sensor (FTS)
enabled in in the hose or run in Hose
System Setup
Resistance Mode with a
screen
properly saved calibra-
tion factor. Follow the
Calibration Procedure,
page
USB drive has Do not remove USB drive
been inserted to until download/upload is
the ADM complete.
Trigger gun to resume
System has
spraying.
entered standby
Turn off standby in setup
screens.
USB down- Enable USB down-
load/uploads are load/uploads on the
disabled Advanced Setup screen
before inserting a USB
drive.
Line frequency is Ensure line frequency
below 45 Hz of incoming power is
between 45 and 65 Hz.
Line frequency is Ensure line frequency
below 45 Hz of incoming power is
between 45 and 65 Hz.
Line frequency is Ensure line frequency
below 45 Hz of incoming power is
between 45 and 65 Hz.
Line frequency is Ensure line frequency
above 65 Hz of incoming power is
between 45 and 65 Hz.
Line frequency is Ensure line frequency
above 65 Hz of incoming power is
between 45 and 65 Hz.
Line frequency is Ensure line frequency
above 65 Hz of incoming power is
between 45 and 65 Hz.
Low material Refill material and update
level drum level on ADM
Maintenance screen.
Alarm can be disabled on
the System Setup screen.
Troubleshooting
68.
21