Replace Hcm; Replace Adm; Software Update Procedure - Graco Reactor 2 Repair Parts

Replace HCM

HCM
Replace Replace HCM
1. Follow Before Beginning Repair, page
2. Open the electrical enclosure and disconnect
all cables from the HCM (603).
3. Remove the nuts (610) and HCM (603).
4. Set rotary switch.
Figure 12 Replace HCM
HCM HCM HCM Rotary Rotary Switch Rotary Switch Positions Switch Positions Positions
0 = Reactor 2, H-30
1 = Reactor 2, H-40
2 = Reactor 2, H-50
3 = Reactor 2, H-XP2
4 = Reactor 2, H-XP3
334946J

Replace ADM

Replace Replace
52. 1. Loosen four screws (142) on the inside of
the electrical enclosure door. Lift up and
pull out to remove ADM (140).
2. Disconnect CAN cable (622).
3. Inspect ADM (140) for damage. Replace if
necessary.
4. Update software by installing an upgrade
token into ADM and cycling system power.
Wait until the update is complete before
removing the token and restarting the
system.
Figure 13
Software Update Software Software
Repair kit GCA modules are shipped
pre-programmed and with upgrade token
(part number 17E206). If software version
upgrade is necessary, follow the procedure in
the manual provided.
ADM
ADM
Update Procedure Update Procedure Procedure
NOTICE
NOTICE NOTICE
Repair
73