Graco Reactor 2 Repair Parts page 58

Repair
3. Place a pan under the reservoir drain plug
(16f) to catch oil.
4. Remove the drain plug (16f).
5. Place a rag around base of oil filter (119)
to prevent oil from spilling. Unscrew filter
1/4-3/4 turn to break air lock in filter. Wait
five minutes to allow oil in filter to drain back
into reservoir. Unscrew filter and remove.
6. Reinstall drain plug (16f).
7. Replace filter (119):
a. Coat filter seal with fresh oil.
b. Screw filter on snug, then an additional
1/4 turn.
8. Refill reservoir with approved hydraulic fluid.
See Table 3.
9. Proceed with normal operation.
NOTE: Upon starting motor, hydraulic pump
NOTE: NOTE:
may make a screeching noise until primed. If
this noise continues for more than 30 seconds,
switch off motor control.
58
Table 3 3 3 Approved Approved Anti Anti- - - Wear
Table Table Approved Anti
Supplier Supplier Supplier
Citgo
Amsoil
BP Oil International
Carl Bechem GmbH
Castrol
Chevron
Exxon
Mobil
Shell
Texaco
* Note: Do not mix mineral-based and
synthetic hydraulic oils. Completely drain oil
from reservoir and pump prior to converting
between oils.
If the approved oils are not available in your
area, use an alternative hydraulic oil meeting
the following requirements:
Oil Oil Type: Oil Type: Anti-Wear (AW) Hydraulic Type:
ISO ISO Grade: ISO Grade: Grade: 46
Viscosity, Viscosity, Viscosity, cSt cSt cSt at at at 40°C: 40°C: 40°C: 43.0-47.0
Viscosity, Viscosity, Viscosity, cSt cSt cSt at at at 100°C: 100°C: 100°C: 6.5-9.0
Viscosity Index: Index: 95 or higher
Viscosity Viscosity Index:
Pour Point, Point, ASTM ASTM D D D 97: 97: -15°F (-26°C) or lower
Pour Pour Point, ASTM 97:
Other essential essential properties: properties: Formulated for
Other Other essential properties:
anti-wear, anti-foaming, oxidation stability,
corrosion protection, and water separation.
Wear (AW) (AW) Hydraulic Hydraulic Oils Oils
Wear (AW) Hydraulic Oils
Name Name Name
A/W ISO Grade 46
AWI ISO Grade 46
(synthetic*)
Energol® HLP-HM, ISO
Grade 46
Staroil HVI 46
Hyspin AWS 46
Rykon® AW, ISO 46
Humble Hydraulic H,
ISO Grade 46
Mobil DTE 25, ISO
Grade 46
Shell Tellus, ISO Grade
46
Texaco AW Hydraulic,
ISO Grade 46
334946J