Replace Belt; Replace Fluid Inlet Sensor - Graco Reactor 2 Repair Parts

Replace Belt

Belt
Replace Replace Belt
1. Follow Shutdown, page
2. Remove the heater cover (134) and the belt
cover fasteners (19).
To prevent damage to the overtemperature
switch, carefully remove the covers.
3. Lift cover (132) and loosen the blue bracket
(131) fasteners. Lift the blue bracket (133)
off of the fasteners and set aside. Remove
the belt covers (131, 132).
4. Remove the belt.
5. Install the new belt and replace the covers.
334946J
50.
NOTICE
NOTICE NOTICE
Replace Fluid Fluid Inlet Inlet Sensor
Replace Replace Fluid Inlet
NOTE: NOTE: For Elite models only. NOTE:
1. Perform Shutdown, page
2. Perform Pressure Relief Procedure, page
3. Disconnect inlet sensor cable from the
fluid inlet assembly. Inspect cable for
damage and replace if necessary. See
Electrical Schematics, page
4. To replace sensor cable:
a. Cut any wire ties and
disconnect from HCM. See
Electrical Schematics, page
To prevent damage to cable, secure cable
with wire ties.
5. Replace sensor and secure with wire ties.
Repair
Sensor
Sensor
50.
105.
105.
NOTICE NOTICE NOTICE
49.
61