Kps034A41> Snow Hood (Intake Side Plate) - Daikin INVERTER FTXM-V Series Engineering Data

FTXM-V Series
13.18 <KPS034A41> Snow Hood (Intake Side Plate)
Component parts
Name
1
Side plate(left)
Shape
Q'ty
CAUTION
● Be sure to follow the contents below as precautions during installation to ensure correct and safe usage.
１． Install at a height and location where maintenance is possible.
２． When installing in a location affected by strong winds, secure the outdoor unit with something such as wire.
３． Avoid installing in locations where the operation sound generated by the outdoor unit affects the neighborhood.
４． Be sure to tighten the screws. Vibration due to screws being loose may result.
Installation of snow hood (suction side)
Install the side plate (left) (1).
１
Install the side plate (right) (2).
２
2
5
Before assembling, check that the following parts are available.
2
Side plate(right)
1 pc.
1 pc.
Please read these"Safety Precautions"carefully before performing installation work.
1
5
Left side panel of
the outdoor unit
Front panel of
the outdoor unit
3 4
Top plate Front plate
1 pc.
1 pc.
１． Install the side plate (left) (1) on the back
of the left side panel of the outdoor unit
using 3 screws (5).
※Assembly is easier if all parts to be attached
to the keyholes are initially installed
loosely using the screws.
※ When used in combination with
an snow hood (suction back)
Place the side plate (left)(1)
1
on the bottom side of the
suction back (left) and
5
tighten together.
Refer to the figure
on the left.
Suction back (left)
１．Install the side plate (right) (2) on the left
side of the front panel of the outdoor unit
using 3 screws (5).
※Assembly is easier if all parts to be attached
to the keyholes are initially installed
loosely using the screws.
221
EDUS042101
INSTALLATION
5 6
Screw
MANUAL
（M4×12）
1 pc.
14 pc.
(this document)
C:3P643416-1