Daikin INVERTER FTXM-V Series Engineering Data page 212

FTXM-V Series
Installation Procedure (2)
Installation Procedure (2)
3. Install the A
CAUTION
• When drilling a hole, be careful not to damage the soundproofing material and other components on the back side.
1) Remove 2 screws from the bottom frame so that the plates of the drain pan heater can be inserted under the heat
exchanger with ease.
2) Lift up the heat exchanger and insert the plates of the
• The ground plate of the drain pan heater should be installed so that it firmly adheres to the bottom frame.
• Install the drain pan heater in a position where it does not come into contact with the fan motor base.
3) Fix the drain pan heater with the
A
Plate (Insert the plate under the heat exchanger.)
A
Hole (Fix with the
View A
4. Route the harnesses.
1) Flex the sheet metal of the outdoor unit and pull the harness around.
Pass the harness
through the slit in the
electrical wiring box
01_EN_3P647274-1.indd 2
drain pan heater.
screws. (3 locations)
B
Heat exchanger
A Drain pan heater
B
B screw.)
Remove 2 screws. (Hexagon tapping screw)
drain pan heater under the heat exchanger.
A
View B
Partition
plate
Screws
B
Secure with
Secure with cable ties (3 locations)
210
EDUS042101
Holes
(2 locations)
Ground plate
(The ground plate should be
installed so that it firmly
adheres to the partition plate.)
C cable tie
3P647274-1
Installat
Installa
2) Connec
termina
5. Cut the j
1) Remove
2) Cut the
6. Install ea
• Be carefu